Posted by tom on May 27, 2012 at 11:49:04:
hi, it was always my dream to build me a cutter body, in my country today, Sunday, it rained a lot,
so I took the opportunity to make feasible "my dream"
I took 10 hours to build and adjust the blades,
I used 10 blades, a 6-inch,
I have not tried to cut, because I was very tired, but in the next few days
I have to try to cut .., I left the tolerance between blade external and internal, internal and
external,
only 0.2 mm,
maybe they are just(0,2 mm) as tolerance,
when begin to cut the test, I decided to paint all the blades, so if the Tolerance and little, the paint
will go away even from the opposite side of the or cutting
this is madness!!!?
look all your considerations, and recommendations
regard tom
My project spiral body and blades