type 36 fellows gearing

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by steve green on February 09, 2014 at 20:13:55:

I have to cut a spline in a lever arm that only fits on my 36". 18 t in part 11 t in cutter. I have all the gears except one which is a 44t to mesh with a 72t. Any suggestions/

Follow Ups:

Re: type 36 fellows gearing Drew 13:53:01 02/13/14 (0)
Re: type 36 fellows gearing Mike 11:49:29 02/12/14 (0)
Re: type 36 fellows gearing Ron V 19:23:44 02/11/14 (0)
Re: type 36 fellows gearing BillS 22:40:33 02/09/14 (6)
- Re: type 36 fellows gearing steve green 07:15:40 02/10/14 (5)
  - Re: type 36 fellows gearing BillS 16:03:06 02/10/14 (4)
    - Re: type 36 fellows gearing mike 15:20:25 02/13/14 (0)
    - Re: type 36 fellows gearing mike 15:20:12 02/13/14 (2)
      - Re: type 36 fellows gearing steve green 19:23:49 02/15/14 (1)
        
        Re: type 36 fellows gearing BillS 08:44:07 02/17/14 (0)

Post a Followup