Posted by BillS on March 04, 2014 at 08:31:46:
In Reply to: Re: DIN 5481 Serration posted by tom on February 28, 2014 at 15:29:54:
There is a general reference that may be of use here. Check out pages 64 - 65. I didn't readily see a reason for the nominal OD being 8.1 - it seems that the lesser numbers would express a negative tolerance as Tom suggested. Then the question in my mind is why three numbers for OD in the spec?
Do the two smaller numbers (7.82 and 7.73) express sizes for Go / NoGo gages?
OmniGear Tech Info Binder
Post a Followup