Posted by tom on March 25, 2014 at 11:55:12:
In Reply to: Re: Problem with CPC-HYP posted by BillS on March 25, 2014 at 10:16:53:
if you say that the ratio is 1.9,
pinion has 40 teeth
gear has 21 teeth
here is where the error ! :-) :-) the pinion is set to a much larger number of gear..
example:
pinion number of teeth n 40 Z1
gear number of teeth N 21 Z2
Drive ratio (1)/(2) 1,90476 Z1/Z2
gear face width F 62 b2
hypoid offset E 25 E
The pitch circle diameter of the big wheel D 434,11 d2
Cutter radius rc 152,4 r0
spiral angle Ψ;po 35 β;10