Re: duplex spread-blade method on gleason 7a


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by BillS on November 07, 2017 at 10:40:57:

In Reply to: Re: duplex spread-blade method on gleason 7a posted by poul on November 07, 2017 at 08:08:57:

Hi Poul,
Tilt is there to compensate for cutter blade angle, to give you a way to use a cutter whose number is not ideal for the job. I suppose tilt might be used to effect a correction to contact location, but I don't have an equation for that.

Could you tell me if you are using CPC-DUP or other software? I'm not sure what software you are talking about when you say "...does not work for it".


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]