spiral bevel gear inverted spiral

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by MD on September 14, 2005 at 12:28:26:

Does anyone kow if a spiral bevel gear can be machined so that the concave side would be the bottom side (as opposed to normally where the bottom side is convex). Some says that it would be refferred to as a "negative" spiral angle. thanx



Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]