Posted by tom on June 08, 2011 at 15:39:25:
Today I started to cut a gear, (spiral gear)
pinion z13 gear z29
modul 10,33
spiral angle 35°
shaft angle 90
FACE WIDTH 50 mm
cutter 12° , pressur angle 20°
I got the computer that the measure in middle-face width,
GEAR FINISHING
NORMAL CHORDAL ADDENDUM 4.45 MM
NORMAL CHORDAL THICKNESS 7.85 MM
pinion
NORMAL CHORDAL ADDENDUM 10.13 MM
NORMAL CHORDAL THICKNESS 14.35 mm
the results are accurate?
there are other ways to measure the teeth?
regard tom