Question for Tom Ramsey about calculating final cut

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Jim Pollock on October 29, 2011 at 23:03:03:

In an old post, Tom Ramsey had given a formula for calculating the amount of final cut when hobbing.

I believe it was measurement over wires - required measurement over wires divided by two and multiplied by 1.37. This was for 20 degree pressure angle.

What would it be for 14 1/2, 25 and 30 degree pressure angle?

Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]