Re: gear shaper MAXICUT operating manual


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Mike on January 20, 2012 at 20:32:24:

In Reply to: Re: gear shaper MAXICUT operating manual posted by inshaajee on January 20, 2012 at 08:49:45:

Feed adjustment is done with the gears that are located on the left hand side of the machine. Both gears add up to 122.The smaller the gear on the the left shaft,the finer the feed. Sorry I am not at work at the moment to give the actual feed rates,But again I believe they are the same as the fellows 7 series machine.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]