Posted by K.SHANMUGAM on July 17, 2012 at 11:58:16:
In Reply to: Re: Drummond MAXICUT 3AR Gear shaper Manual posted by Mike on February 10, 2012 at 04:17:09:
Thank you Mr.Mike
As you mentioned there is a lever underneath
depth mechanism.When we pull the lever out ratchet pawl is indexing two teeths at a time
Job is finished in one revolution-Full depth cut
When we push the lever Ratchet indexing one teeth at a time resulting two rev per full depth
But we want job should finish by two rough cuts and one finish cut totally three passes
Can you guide us in this regard