Differential Formula


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Mark Schneberger on May 14, 2015 at 12:01:01:

We recently purchased a 36H G&E Gear Hobber. The ( hand written ) formula that was supplied with the machine is not producing the correct helix angle. I am using FearFinder 2.0. The example supplied with the machine checks out with this program but the helix angle is off by approx. 2 1/2 degrees. Is there not a data base somewhere with this formula - given the machine serial #?


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]